An Easy-to-Integrate Innovative Impact Kitchen Printer that can Take the Heat
Star Micronics SP742 impact receipt printer was built specifically to work in environments where heat and humidity can erode the type on the kitchen order. This fast two-color printer offers crisp easy to read type for quick viewing. The clamshell design offers easy paper loading and the embedded power supply gives space efficiency. Available interface options include Serial, Parallel, USB and Ethernet.
- Reliable kitchen printer
- Spill proof and heat resistant
- Paper window
- Internal power supply
- Drop-In and Print paper loading
- Auto-cutter
- Black mark sensor
- Paper end sensor
- High-speed throughput: 13 receipts/tickets per minute
- Plug-and-play setup
- Small foot print
- Two color printer (black/red) / Carbon copy printing
- Prints crisp, easy-to read type
- Spill proof design
- Wall mountable
- Horizontal or vertical orientation
- High quality graphics printing
- Printer
- 5ft power cord
- Internal power supply
- 58mm paper guide
- Power switch cover
- Receipt redesign software
- Starter ink ribbon
- Starter bond paper roll
- 2 year manufacturer warranty
- Wall mount bracket
- Vertical stand kit
- Kitchen buzzer
- Ink ribbon
- Bond paper rolls
Frequently Asked Questions:
Power off the printer.
Open the printer cover by sliding the latch toward you.
-IMPORTANT!
DO NOT touch the print head immediately after printing as it can be extremely hot. DO NOT touch the cutter blade. There is a cutter inside the paper outlet slot. Not only should you not put your hand in the paper outlet slot while printing is in progress, NEVER put your hand into the outlet even when printing is not in progress.
When installing the paper roll, the paper must exit from the bottom up (facing you). Set the paper roll into the hollow, and pull on the leading edge of the paper toward you.
Push down both sides of the printer cover to close.
Power off the printer.
Open the front cover by holding the finger grips on both ends of the cover and lift up.
-IMPORTANT!
DO NOT touch the print head immediately after printing as it can be extremely hot. DO NOT touch the cutter blade. There is a cutter inside the paper outlet slot. Not only should you not put your hand in the paper outlet slot while printing is in progress, NEVER put your hand into the outlet even when printing is not in progress.
Place the ribbon cartridge with the ribbon facing inside of printer (non-ink part facing you). The ribbon feed knob on cartridge should be facing up. Turn the ribbon feed knob of the ribbon cartridge in the direction of the arrow to remove slack in the ribbon.
Close the front cover.
Reviews
There are no reviews yet.