Zebra DS9308 Hands-Free Barcode Scanner USB – Black – White

The scanner is in hands-free (presentation) mode when it sits on a counter top, or when it is mounted on a wall using the multi-mount bracket. In this mode, the scanner operates in continuous (constant-on) mode, where it automatically decodes a barcode presented in its field of view. In hands-free mode the LED indicator turns solid green. An aiming dot does not appear.

Yes. To operate the digital scanner in hand-held mode (momentary trigger mode):

1. Pick up the digital scanner and press the trigger. The aiming dot displays.

2. Ensure the aiming dot is centered on the barcode.

3. Press and hold the trigger until either: A. The digital scanner reads the barcode. The digital scanner beeps and the successful decode LED flashes. B. The digital scanner does not read the barcode and the illumination turns off.

4. Release the trigger. The aiming dot reappears. To read another barcode, repeat steps 2 and 3. 

Routinely cleaning the exit window is required. A dirty window may affect scanning accuracy. Do not allow any abrasive material to touch the window.

To clean the scanner:

1. Dampen a soft cloth with isopropyl alcohol 70% or isopropyl alcohol 70% pre-moistened wipes.

2. Gently wipe all surfaces, including the front, back, sides, top and bottom. Never apply liquid directly to the scanner. Be careful not to let liquid pool around the scanner window, trigger, cable connector or any other area on the device.

3. Be sure to clean the trigger and in between the trigger and the housing (use a cotton-tipped applicator to reach tight or inaccessible areas).

4. Do not spray water or other cleaning liquids directly into the exit window.

5. Wipe the scanner exit window with a lens tissue or other material suitable for cleaning optical material such as eyeglasses.

6. Immediately dry the scanner window after cleaning with a soft non-abrasive cloth to prevent streaking.

7. Allow the unit to air dry before use.

8. Scanner connectors:

A. Dip the cotton portion of a cotton-tipped applicator in isopropyl alcohol.

B. Rub the cotton portion of the cotton-tipped applicator back-and-forth across the connector on the Zebra scanner at least 3 times. Do not leave any cotton residue on the connector.

C. Use the cotton-tipped applicator dipped in alcohol to remove any grease and dirt near the connector area.

D. Use a dry cotton tipped applicator and rub the cotton portion of the cotton-tipped applicator back-and-forth across the connectors at least 3 times. Do not leave any cotton residue on the connectors